Forged & Plate Flanges

Lap Joint Flanges are used on piping fitted with lapped pipe or with lap joint stub ends. The lap joint flange with the stub end assembly are normally used in systems requiring frequent dismantling for inspection and cleaning and where the ability to swivel flanges and to align bolt holes materially eases the erection of large diameter or unusually stiff piping. These flanges are also used in applications where there is a need to facilitate bolt alignment. These type of flanges are similar to slip-on flanges. The only difference is that it has a curved radius at the bore and face to accommodate a lap joint stub end. They may be used at all pressures and are available in a full size range. These lap joint flanges slip over the pipe, and are not welded. They are otherwise fastened to it. Here the bolting pressure is transferred to the gasket by the pressure of the flange against the back of the pipe lap.

Material Grade:


Lap Joint flanges have certain special advantages over other flanges. These are as follows:

• Lap Joint flanges have the freedom to swivel around the pipe. This facilitates the lining up of opposing flange bolt holes.
• Lack of contact with the fluid inside the pipe leads to the greater durability of these flanges.
• In piping systems which corrode or erode quickly, the lap joint flanges may be salvaged for re-use.
• The pressure-holding capacity of lap joint flanges is little. But it is better than that of slip-on flanges.
• The Lap Joint works as a backing ring on the stub.
• The main advantage of lap joint flange is that the bolt holes can be aligned with the matching flange after the welds have been completed.
• They allow rotational alignment capability.

Value Added Services:

• Hot Dip Galvanizing
• Electro Polish
• Test Certificate As Per EN 10204 - 3.1 & 3.2

This Flange is designed to be joined to a piping system by butt- welding. It is relatively expensive because of its long neck, but is preferred for high stress applications. The neck transmits stresses to the pipe, reducing stress concentrations at the base of the Flange. The gradual transition of thickness from the base to the neck to the wall thickness at the butt weld provides important reinforcement of the Flange. The bore of the Flange matches the bore of the pipe, reducing turbulence and erosion.

Material Grade:

We are successfully meeting the varied needs of our patrons by offering a wide gamut of DIN Flange as per their precise needs.

Note: Starting Prices are added and prices may vary according to size and material.

Note: Starting Prices are added and prices may vary according to size and material.

The Flange is slipped over the pipe or tube and welded (usually both inside and outside) to provide strength and to prevent leaks. These flanges are at the low cost end of the scale, and do not require high accuracy when cutting the pipe or tube to length. They can sometimes have a boss or hub, and can be made with a bore to suit pipe or tube.

Material Grade:

This is similar to the slip-on Flange in outline, but the bore is threaded, thus enabling assembly without welding. This obviously limits its application to relatively low pressure piping systems. The Flange may be welded around the joint after assembly, but this is not considered a satisfactory method of increasing its use in pressure applications.

Material Grade:

With our years of experience & in-depth knowledge in this field, we are engaged in offering a quality-assured array of Oval Flange.

Note: Starting Prices are added and prices may vary according to size and material.